04-2017 5325 00 13
soliDs
The appliance displays the solid residue full
warning when the number of programmed
dispenses has been reached.
and the “Solid residue full” message is dis-
played.
The appliance will still be able to dispense
instant drinks.
To remove the solid residue container, pro-
ceed as follows:
1. Open the door of the appliance.
2. Grasp the sides of the liquid residue con-
tainer, lift it slightly and pull outwards.
3. Remove the solid residue container,
empty it and wash it with a neutral deter-
gent solution.
4. Reset the fault warning from the “daily
actions” function.
5. Reposition the containers.
3
Fig. 11
1. Liquid residue container
2. Liquid residue container lid fastening hooks
3. Liquid residue container lid
4. Solid residue container*
5. Microswitch for the residue full float valve
6. Liquid residue container full float valve
* Not fitted on instant models.
CLEANING THE BREWING UNIT
After each load or at least once a week, it
is good practice to clean the external parts
of the brewing unit by removing any pow-
CLEANING THE WATER SUPPLY
TANK
For models with a water supply tank only.
being used, the internally-supplied water
tank must be emptied of any residual water
and sanitised, whilst making sure to me-
chanically remove any residues and visible
SWITCHING THE MACHINE ON
Every time you switch on the appliance, it
performs initial checks by dispensing hot
water from the nozzles.
The screen which shows the heating-up
status of the heating unit is displayed.
The selections are not available until the
heating unit has reached its operating tem-
perature.
To Next Page
Loading...
