04-2017 5325 00 51
mDb
crEDit (ovErpay)
You can decide whether to:
-Collect any credit in excess of the selec-
tion amount after a certain time.
-Keep and leave any credit over the selec-
tion amount available for the next selec-
tion.
ovErpay timEout
Makes it possible to set the time when the
credit will be released or collected if a se-
lection hasn’t been made.
maximum crEDit
Allows the maximum accepted value (in
cash) to be set, in order to limit having to
return high coin denominations.
maximum cHaNgE
It is possible to set a limit for the total
amount of change that the coin box will give
when the return change button is pressed
or after a single dispensed beverage.
Any credit exceeding the amount that
has been programmed with this function,
will be cashed in.
accEptED coiNs
recognised by the validator shall be accept-
ed when the coin return tubes are full.
For the coin/ value correspondence, the
checked.
Exact cHaNgE accEptED coiNs
recognised by the validator shall be accept-
ed when the machine is in “exact change”
mode.
For the coin/ value correspondence, the
checked.
rEturNED coiNs
those available in the tubes shall be used
for giving change. This parameter is only
active with coin boxes which do not auto-
matically choose which tube to use (Auto
changer payout).
For the coin/ value correspondence, the
checked.
Exact cHaNgE algoritHm
This allows the control algorithm to be
chosen so that the machine is able to give
change when the selection has been made.
Each algorithm checks a set of conditions
(the amount of coins in the tubes or the
empty or full status) in the tubes which is
then used by the coin box to give change.
The “Doesn’t give change” condition occurs
when the tubes combined with the chosen
algorithm have reached the minimum level
of coins.
For the sake of simplicity, the combination
is described in reference to tubes A, B and
C, where tube A receives the lower value
coins and tube C, the higher value coins.
0 = A or (B and C)
1 = A and B and C
2 = only A and B
3 = A and (B or C)
4 = only A
5 = only A or B (default)
6 = A or B or C
7 = only A or B
8 = only A or C
9 = only B and C
10 = only B
11 = only B or C
12 = only C
E.g. with algorithm “6”, the appliance will
display the “Doesn’t give change” message
when one of the tubes (A,B or C) is at the
minimum level.
With algorithm “04”, the appliance will only
display the “Doesn’t give change” message
when tube A (coin with the least value) has
reached its minimum coin level.
To Next Page
Loading...
