04-2017 5325 00 19
from a taNk
-
pliance; the kit is supplied with installation
and test instructions, which should be scru-
pulously followed in order to maintain the
safety of the appliance.
Place the tank in a clean and protected lo-
cation (closed cabinet), which can easily be
Important!
Kits which have not been approved by the
manufacturer, may not comply with the
safety standards, most especially in re-
gards to live parts.
The manufacturer declines any responsibil-
ity if non-approved components are used.
The installation and subsequent test
operations must be performed by quali-
of the appliance's operation both from
an electrical safety and hygiene point of
view.
DEscalEr
The appliance is not supplied with a
descaler.
In the event that the appliance is connected
to a water mains with very hard water, a
water softener must be installed.
Use descalers with a adequate capacity to
If the appliance uses a water tank, appro-
The cartridges will need to be replaced
periodically depending on the water quality
and the indications given by the manufac-
turer.
The descalers, also available as an acces-
sory, need to be periodically regenerated or
replaced according to the manufacturer's
instructions.
To Next Page
Loading...
