Installation
Edition 10_2010 - 38891EN-900-AB
29
Fitting the doors
Warning – very powerful permanent magnets!
Risk of injury due to crushing.
u On opening and closing the doors, do not grasp the edge of the door.
The doors on the EXAKT 312 are simply hung in the angles on the saw
base unit. A permanent magnet is used as a door catch.
Note An electronically controlled safety circuit ensures the pulleys stop
automatically within 6 seconds on opening the doors. Nevertheless,
ensure the main switch is switched off during all maintenance and
cleaning work!
u Hang the bottom door in the bottom angles on the saw base unit.
u Hang the top door in the top angles on the saw base unit.
u Close doors carefully.
Assembly of the work table, 2nd part
– Push in work plate
– Fit the work table's cutting band guide
– Fit run-off plate
Abb. 18 Assembly of the work table
u Carefully push the work plate 4 from the front along the cutting band
into the work table tray 6. During this process the guide grooves on
the work plate must slide over the collared nuts.
To Next Page
Loading...
