Installation
Edition 10_2010 - 38891EN-900-AB
28
cutting band.
u Manually turn the top pulley clockwise to pre-centre the cutting band
on both pulleys.
Centring the cutting band
The cutting band centres itself on the pulleys. For exact centring of the
band, there is an adjusting lever and a locking lever on the rear of the
EXAKT 312 diamond pathology saw.
r
Abb. 17 Locking lever and adjusting lever for the top pulley
u Turn the locking lever 21 (inner lever) counter-clockwise and in this
way unlock the setting.
u Manually turn pulley clockwise.
u At the same time adjust the adjusting lever 20 (outer lever).
– If you turn the adjusting lever clockwise, the pulley is tilted to the
rear and the cutting band is positioned further forward on the
yellow belt on the pulley.
– If you turn the adjusting lever counter-clockwise, the pulley is tilted
to the front and the cutting band is positioned further back on the
yellow belt.
u Check the centring on the bottom pulley.
u Adjust the centring of the cutting band on both pulleys at the top
pulley as required.
u Tighten locking lever clockwise to secure the setting.
To Next Page
Loading...
