Routine operation
Edition 10_2010 - 38891EN-900-AB
36
u Open the water supply.
u Adjust the flush water flow rate at the flush water control
recommended to fully open the flush water control and to adjust the
flow rate at the water supply valve. This method will prevent excess
water pressure in the system. Then control as necessary at the flush
water control.
u Adjust the cooling water flow rate at the cooling water control 13.
Note: Just a minimum coolant flow rate is generally adequate. It is to
some extent also possible to work without a supply of cooling water,
as enough water is left on the cutting band
by the bottom flush nozzle.
A low cooling water flow rate will prevent heavy splashing during
cutting.
Note If due to statutory hygiene regulations you must collect the waste water
a separate container, only use the cooling water control. In this way the
amount of waste water will be kept as low as possible.
u Switch on the main switch 22.
u Press the acknowledge button 21.
7.2 Undertaking routine operation
Adjusting the height of the top cutting band guide
Danger – risk of injury!
You may suffer injuries if you adjust the top cutting band guide with the
cutting band running.
u Switch off the EXAKT 312.
u Wait until the cutting band has come to a stop.
For an optimum cutting result, the top cutting band guide can be adjusted
to the height of the sample.
Abb. 25 Setting the top cutting band guide
u Place the sample on the work table in front of the cutting band.
u Undo the clamping bolt 19 of the top cutting band guide.
To Next Page
Loading...
