Exakt 312 - Replacing the Cooling Water Hose; Checking the EXAKT 312 Is Level; Mains Cable

Maintenance
Edition 10_2010 - 38891EN-900-AB
52
Replacing the
cooling water
hose
Replacing the cooling water hose
Preparation
u Open the top door.
u Remove the nip guard.
u Remove the cutting band.
u Remove the top pulley.
Replacing the cooling water hose
u Undo union nut on the bulkhead fitting 38, pull off the cooling water
hose 37 and remove the sleeve from old hose.
u Pull the cooling water hose off the elbow fitting 39.
u Fit the union nut over the new cooling water hose.
u Fit the sleeve in the new hose
u Fit the cooling water hose to the bulkhead fitting and tighten the
union nut.
u Fit the cooling water hose to the elbow fitting.
Checking the fitting for leaks
u Open the water supply.
u Open the cooling water control.
u Check the fitting for leaks and re-tighten if necessary.
Assembly
u Fit the top pulley, cutting band and nip guards.
u Close the top door.
The cooling water hose has been replaced.
Aligning the
EXAKT 312
Checking the EXAKT 312 is level
u Adjust the adjustment feet using the open-end spanner AF 17 to
level out any unevenness.
u Place the spirit level on the base plate longitudinally and cross-wise
to check the EXAKT 312 is level.
u Re-adjust adjustment feet if necessary.
See section 5.3 Installing the EXAKT 312.
Checking the
mains cable
Mains cable
u Check the mains cable for damage.
u Have the mains cable replaced by a service engineer if necessary.