Placing in operation for the first time
Edition 10_2010 - 38891EN-900-AB
34
6.3 Checking the cutting band centring
Note Only open the top door once the cutting band has come to a complete
stop.
Abb. 23 Visual inspection of the cutting band centring
u Open top and bottom door.
u Make visual inspection.
The cutting band 3 must be centred on the top and bottom pulley 25.
Note Should the cutting band not be centred, see section Centring the cutting
band in chapter 5 Installation.
u Close doors.
To Next Page
Loading...
