44
9-2-2. Procedure of Replacing Hydraulic Oil
a. Firstly dismantle the right side protection cover as following drawing
Table (1) Table (2)
1. Firstly prepare a proper waste oil tank, reference as table (2)
2. Release the stopper with proper wrench○
1
, before removing the stopper, put a container below to avoid
leaking of oil○
2
3. Remove stopper○
1
, let the waste oil pour into oil tank○
2
, place the stopper at a clean place
4. After the pouring, restore the stopper tightly
5. Transfer the waste oil into a big oil container to prevent pollution
Right Side
Protection Cover
To Next Page
Loading...
