Test Setup - Test Configurator, Timer, and System
NetBlazer 151
Interface (Ethernet, Packet Sync, Fibre Channel, and Wireless)
For Fibre Channel test application:
PSP (Link Protocol) (Primitive Sequence Protocol) check box when
selected (default) allows link management by activating the port.
For CPRI Unframed test application:
Scrambling check box when selected (default) enables the scrambler.
Only available with Unframed CPRI rates 4.9152 Gbit/s and higher.
For CPRI Framed L2 test application:
Sequence indicates the last Startup Sequence State: Standby (A),
L1 Sync (B), Protocol (C), L2 C&M (D), Vendor (E), Operation (F),
or Passive (G).
Protocol defines how the CPRI Startup Sequence negotiates the
protocol version.
Auto can use protocol Version 1 and Version 2 during the
negotiation.
Version 1 negotiates the protocol with Scrambling disabled.
Available with all supported CPRI rates.
Version 2 negotiates the protocol with Scrambling enabled.
Available with CPRI rates: 9.8, 6.1, and 4.9 Gbit/s.
Protocol table indicates either the last received (Version 1 or Version
2) or negotiated (Auto) protocol version. A light-red background
indicates a Protocol version mismatch between the received value and
the expected generated value.
To Next Page
Loading...
