EXFO FTB-860 - Link OAM

Test Setup - Test Configurator, Timer, and System
170 FTB-700G/800 Series
Link OAM
Link OAM
From the test menu, tap Setup, Test Configurator, and the
Link-OAM (802.3) test block.
OAM Mode
Allows the selection of the OAM mode:
 Active (default) initiates the OAM discovery and send OAMPDU
loopback control; doesn’t respond to variable request nor generate
Link Event Notification.
 Passive doesn’t initiate OAM discovery nor send OAMPDU loopback
control.
OAMPDU Destination MAC Address
Indicates and allows to change the default multicast OAM PDU destination
MAC address: 01:80:C2:00:00:02.
Default check box when cleared (default is selected), allows the
configuration of the OAM PDU destination MAC address:
00:00:00:00:00:00 to FF:FF:FF:FF:FF:FF.
Pass/Fail Verdict
Pass/Fail Verdict check box when selected (default) enables the use of the
pass/fail verdict. A global fail verdict is declared when any of the following
condition is met: Link Down, any Link OAM alarm, Remote Alarms (if
enabled), or Remote Loopback (if enabled).
 Remote Alarms check box when selected (default) considers the
following alarms to declare the pass/fail verdict: Critical Event, Dying
Gasp, and Link Fault.
 Remote Loopback check box when selected (default) considers
successful/unsuccessful remote loopback request to declare the
pass/fail verdict.