Test Setup - Test Configurator, Timer, and System
NetBlazer 241
Signal (Transport)
Signal (Transport)
From the Test menu, tap Setup, Test Configurator, the interface block,
and the Signal tab.
Physical Interface - Optical
Note: For electrical interface, see Physical Interface - Electrical on page 242.
Laser indicates the status of the laser: ON with the laser pictogram
(emitting an optical laser signal) or OFF.
TX Power (dBm) indicates, when supported, the transmit power level
of the optical laser in dBm.
Wavelength (nm) indicates, when supported, the detected laser
wavelength.
RX Power (dBm) indicates, when supported, the current received
power level of the optical laser in dBm.
Green: Power level in range.
Yellow: Power level out-of-range.
Red: Loss of signal or power level is close to damage.
Gray: Invalid operational range value.
Min RX Power (dBm) indicates, when supported, the minimum
received power level of the optical laser in dBm.
Max RX Power (dBm) indicates, when supported, the maximum
received power level of the optical laser in dBm.
To Next Page
Loading...
