Test Setup - Test Configurator, Timer, and System
NetBlazer 191
Network Details (iSAM)
Network Details (iSAM)
Either select the Layer parameter, the number of services, for each service
the profile and CIR settings, or click on More for all settings. The total
bandwidth (when the Performance Test is enabled) and the estimated
test duration are also displayed.
From the Test menu, tap Setup, Test Configurator, and the More button
from the Network block.
iSAM
Layer is the layer used for all services. The layer is fixed to L3/L4 when
the RFC 6349 Test is enabled.
L2 (default) for Ethernet II.
L3/L4 for Ethernet II, IP (IPv4), and respectively UDP for the
Configuration and Performance subtests, and TCP for RFC-6349
subtest.
Classification defines the traffic classification used in the provider
network: VLAN ID, VLAN Priority, or DSCP (available with layer L3/L4).
Note: At least one check box (Configuration Test, or Performance Test, or
RFC 6349 Test) has to be selected.
Configuration Test check box when selected (default) verifies if the
network configuration is correct for each service before starting a long
term test (Performance Test).
Set the Configuration Test duration in seconds per step enabled (CIR
and CIR+EIR): 5 seconds (default) to 60 seconds.
To Next Page
Loading...
