Test Setup - Test Configurator, Timer, and System
NetBlazer 217
RFC 6349
RFC 6349
From the Test menu, tap Setup, Test Configurator, and the RFC 6349
block.
Connection
Operation Mode indicates the test operation mode: Dual Test Set
(DTS). It is possible to select a remote unit by clicking on the Discover
Remote button.
Disconnected indicates that there is no connection established with a
remote module.
Connected indicates that the connection is established with a remote
module.
Discover Remote button allows to discover remote modules
supporting Dual Test Set. For more details, refer to Discover Remote
Button on page 530.
Direction allows the selection of the traffic direction: Local to Remote,
Remote to Local, and Bidirectional (default).
Parameters
Multiple Connections check box when selected (default) indicates
that the applicable TCP Throughput phases are performed with
multiple connections; otherwise TCP Throughput phases are
performed within a single connection.
TCP Server Port
Local TCP Server Port is the port used by the server located at the local
side: 1 to 65535 (excluding 62819 that is used for DTS connection),
default is 50201.
Remote TCP Server Port is the port used by the server located at the
remote side: range is 1 to 65535 (excluding 62819 that is used for DTS
connection), default is 50201.
To Next Page
Loading...
