Test Setup - Test Configurator, Timer, and System
NetBlazer 227
S-OAM and MPLS-TP OAM
Requesting MEP ID TLV (G.8113.1) check box when selected (default)
determines if the Requesting MEP ID TLV is present in the LBM frame.
The Requesting MEP ID TLV check box is cleared and not selectable
when the Continuous check box is selected.
Priority, available with S-OAM Mode or when VLAN is enabled (see
VLAN on page 190), allows to select the VLAN user priority: 0 (default)
to 7. Refer to VLAN ID and Priority on page 639 for more information.
Drop Eligible, available with S-OAM Mode or when VLAN is enabled
(see VLAN on page 190), when set to Yes (DEI = 1), the transmitted
frames will be dropped first on receipt when congestion occurs under
test. Drop Eligible is only configurable with Unicast address type,
otherwise is set to No (Default). Drop Eligible is set to No for Frame
Delay, Frame Loss, and Synthetic Loss functions.
Period determines the transmission period of frames which is set to
100 ms. Period is not applicable for Multicast address type or when the
Continuous check box is selected.
TX Rate (%) is the transmission rate of the LBM frame: 0.0001 to 95%
for 10M, 99.5% for 100M, 99.95% for 1G, 99.995% for 10G LAN, and
92.8521% for 10G WAN. Only available with Loopback test function
when the Continuous check box is selected.
To Next Page
Loading...
