Test Setup - Test Configurator, Timer, and System
NetBlazer 231
Services - Global
Framing indicates the framing of each service. Tap on the Framing
button to modify the Frame Format, Network Layer, Transport Layer,
VLAN, S-OAM MEG/MD Level, and MPLS when applicable (see Modify
Frame Structure from the MAC/IP/UDP on page 172).
VLAN (ID/Priority) indicates the ID and Priority of each VLAN level for
each service. Tap on the VLAN button to modify the VLAN settings (see
VLAN from the MAC/IP/UDP on page 172).
Addressing indicates the source and destination IP or MAC addresses
for each services. Tap on the Addressing button to modify the
addressing (see MAC and IP from the MAC/IP/UDP on page 172).
Batch button allows bulk configuration for services addressing. Select
the check box of each configuration parameter that needs to be copied
and set its parameters. From Apply To, select all services the copy
applies to and tap on the Copy From to proceed.
SLA Button
The SLA parameters are displayed and configurable per service. Click on
the desired column button to access the configuration settings.
See General Button on page 230 for more information on check boxes,
Direction, and Service Name.
See SLA Parameters on page 238 for more information on CIR, CIR+EIR,
CBS, EBS, Max Jitter, Max Latency, and Frame Loss.
To Next Page
Loading...
