Test Setup - Test Configurator, Timer, and System
NetBlazer 251
Signal - Signal Configuration (DSn/PDH)
RX
Apply Channel TX to RX, available for decoupled test, allows to apply
the RX payload content based on the TX settings. None will be used
when TX is set to either Idle or Tone.
Note: The RX timeslot selection is only configurable in a Decoupled topology
when the Apply Channel TX to RX check box is cleared. A warning is
displayed when the number of Pattern timeslot does not match between TX
and RX. This is to ensure pattern continuity between the TX and RX
interface in a MUX/DEMUX test even if used through a cross-connect device.
Select the payload content by tapping once or several times on each
timeslot until the desired content appears.
Pattern (default) uses the pattern from the received signal.
None does not use the pattern.
To Next Page
Loading...
