Test Setup - Test Configurator, Timer, and System
NetBlazer 273
Streams - Profile
Frame Loss Count/Rate check box when selected enables the Frame
Loss pass/fail verdict and allows to set threshold of frame that are lost.
For Count, enter the maximum count of frame that are lost before
declaring a fail verdict: 0 (default) to 9999999999.
For Rate, enter the maximum rate of frame that are lost before
declaring a fail verdict: 1.0E-14 (default) to 1.0E00.
Out-of-Sequence Count/Rate check box when selected enables the
Out-of-Sequence pass/fail verdict and allows to set the threshold of
frames that are Out-of-Sequence.
For Count, enter the maximum count of frames that are
Out-of-Sequence before declaring a fail verdict: 0 (default) to
9999999999.
For Rate, enter the maximum rate of frames that are Out-of-Sequence
before declaring a fail verdict: 1.0E-14 (default) to 1.0E00.
Jitter (ms) check box when selected enables the Jitter verdict and
allows to set the maximum Jitter in ms before declaring a fail verdict.
Latency (ms) check box when selected enables the Latency verdict
and allows to set the maximum Latency in ms before declaring a fail
verdict.
To Next Page
Loading...
