Test Results
NetBlazer 395
Summary
Traffic / Traffic Ethernet
Note: The Traffic statistics are available for Smart Loopback and Through Mode
test applications. See Traffic - Ethernet on page 446 for more information.
CPRI
Note: Available with CPRI Framed L2.
Sequence indicates the last Sequence State parameter: Standby (A),
L1 Sync (B), Protocol (C), L2 C&M (D), Vendor (E), Operation (F),
and Passive (G). The pass/fail verdict is also displayed when enabled.
Frame Sync indicates that the startup sequence synchronization status
as per L1 Sync Status parameter: active (green) or inactive (red).
Protocol indicates either the last received (Version 1 or Version 2) or
negotiated (Auto) protocol version. A red background indicates a
Protocol version mismatch.
C&M indicates either the received (HDLC or Ethernet) or negotiated
(Auto) C&M for Ethernet subchannel and HDLC rates in Mbit/s. A red
background indicates either a C&M type mismatch or HDLC
Rate/Ethernet subchannel mismatch. An arrow is displayed indicating
which C&M Channel, Ethernet or HDLC, is selected following the
negotiation process.
Code Word (CW) indicates the transmitted and received Code Word
count.
Hyperframe indicates the transmitted and received hyperframe count.
L1 Reset, available when Remote Radio Head emulation mode is
selected, indicates the number of times a request to reset the RRH
interface was received.
To Next Page
Loading...
