Test Results
412 FTB-700G/800 Series
Summary (iSAM)
For Dual Test Set the following values are reported for both local to remote
(L->R) and remote to local (R->L).
Service indicates the service’s number and name.
The pass/fail verdict icon is displayed next to the service name
indicating if the service complies to the configured SLA parameters.
TX CIR (Mbit/s) indicates the transmitted Committed Information Rate.
FD (ms) (RTT
1
) (Latency) indicates the maximum measured
round-trip latency (Frame Delay). The pass/fail verdict is also
displayed.
IFDV (ms) (Jitter) indicates the maximum measured Inter Frame
Delay Variation. The pass/fail verdict is also displayed.
FLR (%) (Frame Loss) indicates the maximum percentage of frames
that are lost (Frame Loss Ratio) from the CIR step. The pass/fail verdict
is also displayed.
RX Rate (Mbit/s) indicates either the measured maximum utilization
throughput for Service Configuration Test or the measured average
utilization throughput for Service Performance Test. The pass/fail
verdict is also displayed.
Total RX Rate, available for Service Performance Test, indicates the
average utilization throughput for all services (both directions are
displayed for Dual Test Set).
1. RTT is only displayed for Dual Test Set.
To Next Page
Loading...
