EXFO FTB-860 - Page 446

Test Results
434 FTB-700G/800 Series
Summary (S-OAM and MPLS-TP OAM)
 RX Line Utilization meter and value, available with Loopback
function, indicate the line rate utilization percentage (only LBR frames
are considered) received in the last second.
 TST RX Rate meter and value, available with Test function, indicate the
quantity of TST frames received in the last second.
 Frame Delay meter and value, available with Frame Delay function,
indicate the average of the measured frame delays in the last second.
 Frame Loss Ratio meter, available with Frame Loss function,
indicates for both Near-End and Far-End the last measured frame loss
ratio in the last second.
 Synthetic Loss Ratio meter, available with Synthetic Loss function
which is available with Ethernet OAM, indicates for both Near-End and
Far-End the last measured Synthetic Loss ratio in the last second.
Note: Refer to S-OAM and MPLS-TP OAM on page 379 for more
alarms/errors/statistics information.
Summary
Refer to S-OAM and MPLS-TP OAM on page 379 for more information on
alarms.
Thresholds
Refer to Thresholds on page 222 for more information.