Test Control
NetBlazer 531
Discover Remote Button
Status indicates the status of the remote module.
Loop Up and Loop Down buttons (Not available with RFC 6349 test
application)
Loop Up establishes the connection with the selected remote
module and sets the remote module into Smart Loopback test
application.
If a remote module is in any busy status a user confirmation is
required to proceed with the Loop Up command.
Following a successful loop up, the IP address of the remote
module will be used as the destination IP address for the test.
Once the connection is established with the remote module, the
local module can be set for EtherSAM, RFC 2544, EtherBERT, or
Traffic Gen & Mon testing.
Loop Down ends the connection between the local and the
remote modules.
Status Description
Idle-<test application>
a
a. Possible test applications: EtherSAM, RFC 2544, RFC 6349, EtherBERT,
Traffic Gen & Mon, Smart Loopback, Through Mode, TCP Throughput,
Carrier Ethernet OAM, Cable Test, 1588 PTP, or SyncE.
The specified test application is selected but not
running.
Busy-<test application>
b
b. Possible test applications: EtherSAM, RFC 2544, RFC 6349, EtherBERT,
Traffic Gen & Mon, Smart Loopback, TCP Throughput, Carrier Ethernet OAM,
1588 PTP, or SyncE.
The specified test application is running.
Not Responding No response from the specified IP address (only
possible when Ta r g e t is set to Specific IP).
To Next Page
Loading...
