Selecting and Starting a Test
NetBlazer 75
Intelligent Apps
4. Tap the Start button from the right navigation bar to start the test (refer
to Start/Stop|TX Button on page 558). If the connection with the
remote module is not established with either DTS or Remote
Loopback mode, the automatic remote connection process is
performed before starting the test. The Summary result page will be
automatically displayed when the test is started from any Setup
configuration page. For additional results refer to Test Results on
page 287.
5. When the test ends automatically or is manually stopped, the generate
report pop-up is displayed by default. If required, tap Yes to generate a
report of the test results and statistics (refer to Report Button on
page 547 for more information).
To Next Page
Loading...
