EasyManuals Logo

Extreme Networks ExtremeSwitching X440-G2 Series User Manual

Extreme Networks ExtremeSwitching X440-G2 Series
413 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #180 background imageLoading...
Page #180 background image
4 Install one or two power supplies (for switches that require them) and connect to an electrical
source.
See Installing Internal Power Supplies on page 185.
Note
Be aware of whether you are installing an AC-powered switch or a DC-powered switch.
The installation instructions are dierent depending upon what type of power is used.
5 Connect power to the switch.
See Connecting Power to the Switch on page 219.
6 For a stacked configuration, connect stacking cables.
See Connecting the Switches to Form the Stack Ring on page 170.
7 Connect network interface cables.
See Connecting Network Interface Cables on page 220.
8 Perform initial network connection and configuration.
See Performing Initial Management Tasks on page 220.
Safety Considerations for Installing Switches
Read the information in this chapter thoroughly before you attempt to install or remove an Extreme
Networks switch.
Ensure that proper ESD (electrostatic discharge) controls are in use before switch maintenance is
performed. This includes but is not limited to wrist straps that are grounded to the switch housing and
earth grounds.
Warning
Connect the chassis ground wire before you connect any DC power cables.
Disconnect the ground wire after you disconnect all DC power cables.
Take care to load the equipment rack so that it is not top-heavy. Start installing equipment at the
bottom of the rack and work up.
Do not cover vents that would restrict airflow.
Note
See Safety and Regulatory Information on page 396 for additional safety information.
See Technical Specifications on page 315 for additional information regarding regulatory
compliance certifications.
Pre-installation Requirements
Prepare the site for the installation, and ensure that you have the appropriate people and tools on hand.
Installing most ExtremeSwitching series switches requires two people to maneuver the switch and
attach mounting hardware.
Installing Your Extreme Networks Switch
ExtremeSwitching and Summit Switches: Hardware Installation Guide 180

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Extreme Networks ExtremeSwitching X440-G2 Series and is the answer not in the manual?

Extreme Networks ExtremeSwitching X440-G2 Series Specifications

General IconGeneral
Form FactorRack-mountable
VLAN SupportYes
Humidity5% to 95% non-condensing
ModelX440-G2 Series
Port TypeGigabit Ethernet
Switching Capacity176 Gbps
Forwarding Rate131 Mpps
StackingYes, up to 8 switches
Layer SupportLayer 2/3
Operating Temperature0°C to 50°C
Product TypeSwitch
Jumbo Frames9216 bytes
AC Power Supply100-240 VAC, 50-60 Hz
Storage Temperature-40°C to 70°C
Port Configuration24 or 48 ports
Power over Ethernet (PoE)Optional

Related product manuals