EasyManuals Logo

Extreme Networks ExtremeSwitching X440-G2 Series User Manual

Extreme Networks ExtremeSwitching X440-G2 Series
413 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #266 background imageLoading...
Page #266 background image
7 Push the power supply in until the latch snaps into place.
Caution
Do not slam the power supply into the switch.
Figure 209: Installing A Summit 350 W or 715 W AC Power Supply
8 Connect the power cord to the power supply and to a grounded AC power outlet.
Warning
Always be sure that the source outlet is properly grounded before plugging the AC power
cord into the AC power supply.
9 If the power supply is equipped with a power cord retainer, use the retainer to secure the power cord
to the power supply.
Replacing a Summit 550 W AC Power Supply
Summit 550 W power supplies are available for switches with either front-to-back or back-to-front
airflow.
You need the following tools and materials to replace a 550 W AC power supply:
Thermal protective gloves
AC power cord, if you will not be re-using the cord from the removed power supply
An AC power cord is not included with the Summit AC power supply. You must obtain a power
supply cord that meets the requirements listed in Power Cord Requirements for AC-Powered
Switches and AC Power Supplies on page 393.
In a switch with a redundant power configuration, you can replace one Summit AC power supply
without powering down the switch.
Replacing AC Power Supplies
ExtremeSwitching and Summit Switches: Hardware Installation Guide 266

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Extreme Networks ExtremeSwitching X440-G2 Series and is the answer not in the manual?

Extreme Networks ExtremeSwitching X440-G2 Series Specifications

General IconGeneral
Form FactorRack-mountable
VLAN SupportYes
Humidity5% to 95% non-condensing
ModelX440-G2 Series
Port TypeGigabit Ethernet
Switching Capacity176 Gbps
Forwarding Rate131 Mpps
StackingYes, up to 8 switches
Layer SupportLayer 2/3
Operating Temperature0°C to 50°C
Product TypeSwitch
Jumbo Frames9216 bytes
AC Power Supply100-240 VAC, 50-60 Hz
Storage Temperature-40°C to 70°C
Port Configuration24 or 48 ports
Power over Ethernet (PoE)Optional

Related product manuals