Extreme Networks ExtremeSwitching X440-G2 Series User Manual

3 Open the clip and slip it over the barrel of the connector.
Figure 181: Attaching the Power Cord Retainer on the 750 W AC Power Supply
4 Snap the clip firmly around the connector.
5 Connect the other end of the power cord to an AC power outlet.
Warning
Always be sure that the source outlet is properly grounded before plugging the AC power
cord into the AC power supply.
Caution
Make sure that the AC power supply circuit is not overloaded. Use proper overcurrent
protection, such as a circuit breaker, to prevent overcurrent conditions.
Installing an RPS-150XT Redundant Power Supply
You can install the RPS-150XT power supply on a flat surface or in a 19-inch rack in the three-slot
modular shelf (STK-RPS-1005CH3), which is available for purchase separately.
Caution
Observe all ESD precautions when handling sensitive electronic equipment.
Only qualified personnel should install redundant power supply (RPS) units.
Unpacking the RPS-150XT
To prevent electrostatic damage, attach an electrostatic discharge (ESD) wrist strap to your wrist before
handling the RPS-150XT.
Installing External Power Supplies
ExtremeSwitching and Summit Switches: Hardware Installation Guide 233

Extreme Networks ExtremeSwitching X440-G2 Series Specifications

General

Form Factor	Rack-mountable
VLAN Support	Yes
Humidity	5% to 95% non-condensing
Model	X440-G2 Series
Port Type	Gigabit Ethernet
Switching Capacity	176 Gbps
Forwarding Rate	131 Mpps
Stacking	Yes, up to 8 switches
Layer Support	Layer 2/3
Operating Temperature	0°C to 50°C
Product Type	Switch
Jumbo Frames	9216 bytes
AC Power Supply	100-240 VAC, 50-60 Hz
Storage Temperature	-40°C to 70°C
Port Configuration	24 or 48 ports
Power over Ethernet (PoE)	Optional