Extreme Networks ExtremeSwitching X440-G2 Series User Manual

RPS-500p Redundant Power Supply Technical Specifications
External Power Supplies for PoE Switches
The following tables list the specifications for the 500 W DC RPS-500p (model 10923).
Table 286: Physical Specifications
Dimensions 4.45 H x 44.5 W x 16.5 D (cm) 1.75 H x 17.5 W x 6.5 D (in)
Weigh (unit only) 3.47 kg (7.63 lb)
Weigh (unit and packaging) 4.95 kg (10.89 lb)
Table 287: Power Specifications
AC input frequency 50/60 Hz (range 47-63 Hz)
AC input voltage 100-240 V (range 90-264 V )
AC input current 8 A maximum
DC output -54 V , 7.8 A maximum
+12.0 V , 14 A maximum
Maximum DC output power 500 W
Table 288: Environmental Specifications
Operating temperature 0°C to 50°C (normal operation) (32°F to 122°F)
Storage temperature -40°C to 70°C (-40°F to 158°F)
Operating humidity 5% to 95% relative humidity, non-condensing
RPS-500p Connector
See Figure 254 and Table 289 on page 387 for pin locations and function.
Note
The following information is for troubleshooting purposes only. For proper operation, use only
the 1 meter RPS cable supplied with the RPS-500p. This cable is specially designed for this
application and meets all necessary regulatory and safety standards. The use of non-
approved cables will void your warranty.
Technical Specifications
ExtremeSwitching and Summit Switches: Hardware Installation Guide 386

Extreme Networks ExtremeSwitching X440-G2 Series Specifications

General

Form Factor	Rack-mountable
VLAN Support	Yes
Humidity	5% to 95% non-condensing
Model	X440-G2 Series
Port Type	Gigabit Ethernet
Switching Capacity	176 Gbps
Forwarding Rate	131 Mpps
Stacking	Yes, up to 8 switches
Layer Support	Layer 2/3
Operating Temperature	0°C to 50°C
Product Type	Switch
Jumbo Frames	9216 bytes
AC Power Supply	100-240 VAC, 50-60 Hz
Storage Temperature	-40°C to 70°C
Port Configuration	24 or 48 ports
Power over Ethernet (PoE)	Optional