A952 37 532310 - Rev.A
90°
23
5
7 Nm
22
2
a
b
1 1
6
10 Nm
■ INSTALLING THE ARM
1. Make sure that the 6 screws (22-1) have not been fully tightened and that they allow the two rods to
slide inside the guide.
2. Fasten the bracket horizontally (22-2) using the screws supplied (metric "a" or self-tapping "b" for
wood) in correspondence with the holes or points that were previously marked as indicated in the installation
diagram for the specific installation (1- 7).
3. Keep the door closed.
4. Make sure that the guide is perpendicular to the surface to which it is fixed (23) and slide the two inner
rods until it is possible to connect the arm to the gearmotor.
L
This figure shows one of the possible applications. In any application, the guide, with the door closed and the
arm inserted, must be perpendicular to the fixing surface.
To Next Page
Loading...
