Fargo HDP5000 User Manual

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.3)
5-18
Troubleshooting with the LCD Error Message Table (continued)
LCD Error Message Cause Solution
No Smart Encoder
(PC Error Message
No. 33)
You are trying to send
encoding data, but the
Printer is not configured with
this Encoder type.
To cancel, click on Cancel
Print.
Printing Error
(PC Error Message
No. 107)
An error was detected during
printing.
Reset the Printer and try
again.
If this problem persists, call for
technical assistance.
Reboot Required
(PC Error Message
Nos. 9, 65, 67, and
163)
Unspecified system error
detected by the Printer
Firmware.
Reset the Printer and try
again.
If this problem persists, call for
technical assistance.
Reinsert Ribbon
(PC Error Message
No. 141)
The Ribbon must be
reinserted for proper
functioning of the Printer.
Reinsert the Ribbon or press
Resume.
Remove Card
(PC Error Message
No. 68)
A card is jammed in the Print
Station or card flipping area
of the Printer.
Clear the jam and press
Cancel.
Remove Ribbon
(PC Error Message
No. 139)
The print Ribbon is not
installed properly or has
been damaged.
Verify the correct Ribbon is
installed in the Ribbon
Cartridge.
Remove it and replace it with
the correct Ribbon.

Fargo HDP5000 Specifications

General

Maximum resolution	300 x 300 DPI
Print speed (color)	7 card/h
Print speed (monochrome)	14 card/h
Product color	Black
Internal memory	16 MB
Total input capacity	100 sheets
Compatible operating systems	Windows 2000 / XP / Server 2003 / Vista (32 bit) Mac OS X v10.4 / v10.5 Linux

Weight and Dimensions

Weight	7300 g
Dimensions (WxDxH)	313 x 235 x 292 mm