RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.3)
9-25
Using the Transfer Temp Offset Option
This option adds an offset to the temp the printer is reading from the transfer roller. (Note:
This setting should be used only make the temp of the transfer roller and the goal on LCD
match.)
• Use the slider on “Image Transfer” tab to make adjustment for card stock. (Note: A “-”
Adjustment will increase the actual temp of roller.)
Print Tension Settings
Using the Ribbon Print Takeup Tension Option
This procedure controls the tension of the color Ribbon during printing.
• Adjust the Ribbon tension if the Ribbon wrinkle is appearing on the card. (Note:
Adjustments moderately change the image length.)
Using the Film Print Takeup Tension Option
Caution: The Film Drive sets the baseline for the Film Tension and should not be adjusted
by the reseller or the end User.
• Adjustments moderately change the image length.)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
