RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.3)
9-30
Using the Cleaning rate Option
The message to clean the printer uses a defaulted number of passes of 3000 and to change
this click up or down one number per one card.
Using the EAT Disable Option
This is and ON or OFF switch. 0 is off and 1 is on. This will tell the printer to keep track of the
environmental temperature and compensate for it.
“Environmentally Adaptive Transfer” automatically adjusts the transfer temp based on the
ambient air conditions within the printer. Will increase or decrease the transfer roller temp by
as much as 20C in extreme conditions.
This mode defaults to on and a setting of “1” will disable.
Using the Film Print Cooling Level Option
This controls the speed of the transfer roller cooling fan during the printing process.
This setting should normally be off, but can be turned on to help with splotchy color areas on
the image. Too high fan speed can cause smudge.
Using the Film Transfer Cooling Level Option
This controls the default speed of the cooling fan for the transfer process.
Adjusts fan speeds and on times during transferring. This setting affects both flash and
smudge.
Using the Enable Ribbon Wrinkle Compensation Option
This is an on or off switch. When this enabled it will turn on extra pixels on the printhead to
help with ribbon wrinkle during the print process.
Using the Lamination Top of Form Option
This option changes location of patch(s) over length of card
Using the Lamination End of Form Option
This option changes head lift at end of card
Using the Lamination Bottom Takeup Option
This option changes tension of Laminate roll 1.
Using the Lamination Top Takeup Option
Changes tension of Laminate roll 2 (if equipped)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
