Fargo HDP5000 - Page 394

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.3)
17-2
Dither, 16-5
dither method, 8-44
DMA (Direct Memory Access), 16-3
Dongle, 16-5
Dot, 16-5
Dot pitch, 16-5
Download, 16-5
DPI (Dot Per Inch), 16-5
DRAM (Dynamic Random Access Memory), 16-5
Driver, 16-6
Duplex Printing, 16-6
dwell temperature, 8-15
Dwell Time, 8-7, 16-6
Dye Migration, 16-6
Dye-Sub Intensity slide, 8-41
dye-sub printed image, 8-41
Dye-Sublimation, 2-16, 16-6
Dye-Sublimation Cyan Panel, 2-20
Dye-Sublimation Magenta Panel, 2-20
dye-sublimation Ribbon Panels, 8-41
Dye-Sublimation Yellow Panel, 2-20
E
E-card, 16-6
E-card Docking Station, 16-6
ECP Mode (Enhanced Capabilities Port Mode), 16-7
Edge-to-Edge, 16-7
Edge-to-Edge printing, 8-15
EE Memory, 16-7
EEPROM (Electrically Erasable Programmable Read
Only Memory), 16-7
embedded contaminants,
2-21
Emissions Standards, 2-5
Encode Station, 2-19
Encoder (Smart Card), 16-7
Encoder (wheel), 16-7
encoding instructions, 8-36
Encoding Mode, 8-66
Encoding Options, 2-10
End Sentinel (ES)., 8-78
Engine, 16-7
EOF (End Of Form), 16-7
EPP (Enhanced Parallel Port), 16-7
EPROM (Electronically Programmable Read Only
Memory), 16-8
Escape sequence, 16-8
ESD, 1-2, 8-1, 10-2
ESD (ElectroStatic Discharge), 16-8
Ethernet, 16-8
F
factory default settings/Default button, 8-58
Fargo Technical Support, 14-1
Fargo Technical Support via the Web, 14-1
feed card into Encoder, 5-38
Feeder Station, 2-19
Field Separator (FS), 8-78
Film, 16-8
Firmware, 16-8
Flash Memory, 16-8
Flipper Module Field upgrade, 4-5
Font, 16-8
FPGA (Field Programmable Gate Array), 16-8
Full bleed, 16-9
Full Card option, 8-94
Functional Specifications, 2-16
G
Gamma, 16-9
Glossy / Matte, 16-9
Glossy PVC, 16-9
Glossy-PVC or Matte-PVC options, 8-58
Graphical Device Interface (GDI), 16-9
Gray Scale, 16-9
Gray/Align YMCK, 5-39
H
Halftoning, 16-9
Hard Drive, 16-9
hard Drive space
adequate or inadequate, 5-38
Hardware, 16-9
HDP (High Definition Printing™), 16-9
HDP Cards-Matte PVC + H Panel Ribbon
(2)
,
8-4
HDP Cards-Matte PVC + non-H Panel Ribbon, 8-4
HDP Film, 8-58
HDP Film Options, 2-11
HDP Film particles, 8-7
HDP Film Storage Temperature, 2-11
HDP Film transfer parameters, 8-2
Head, 16-10
Heat Seal, 8-2, 16-10
Heat sink, 16-10
HiCo (High Coercivity), 16-10
High Coercivity UltraCard IIIs, 8-66
holographic-type overlaminates, 2-27
Horizontal adjustment, 8-54
HTML (HyperText Markup Language), 16-10
HTTP (HyperText Transfer Protocol), 16-10
Humidity, 2-11
I
IC (Integrated Circuit), 16-10
IC smart cards/proximity cards, 8-2
ID (Identification), 16-10
ID format, 8-30
ID software applications, 8-78
IEEE 1284 (Institute of Electrical and Electronics
Engineers 1284), 16-10
Image, 16-10
Image color tab, 8-43
Image orientation, 8-53
Image Position controls, 8-53
Image Transfer tab, 8-15
Input, 16-11
Input Hopper, 16-11
Input Hopper Card Capacity, 2-11
Interface, 2-11
Intermediate Transfer Media (InTM), 16-11