FENDT 926 Vario User Manual

236
FAULTS AND REMEDIAL ACTIONS
Power lift and PTO automatic mode
Text-module
Hydraulic system (push button / flow controller)
Text-module
Other fault codes
Text-module
Rear PTO
Fault code Cause Effect and remedy
5.1.91 Joystick rear automatic mode
on/off button faulty.
Rear automatic mode not working.
5.1.93 Joystick front automatic mode
on/off button faulty.
Front automatic mode not functioning.
5.1.95 Joystick automatic mode stop
button faulty.
Automatic mode cannot be switched on
and off.
Fault code Cause Effect and remedy
5.1.98 Control pump oil pressure mo-
nitoring faulty.
Possible failure of work hydraulics.
5.1.99 Signal of flow control sensor
disturbed or no oil pressure on
the auxiliary pump.
Possible failure of auxiliary pump (con-
stant displacement pump).
Fault code Cause Effect and remedy
5.1.00 Control unit fault. E-Box faulty.
5.1.8D Checksum error. Old automatic
mode configuration data.
Reduced comfort.
5.1.8F Checksum error. Old automatic
function sequential data.
Reduced comfort.
5.1.9A Plausibility check error on flow
controller with ignition ON and
engine OFF.
No pressure monitoring.
5.1.9B 8 bar pressure switch faulty. No pressure monitoring.
5.1.B0 Initialisation error on communi-
cation driver. CAN bus commu-
nication restricted.
EOL programming.
5.1.9E Engine coolant level too low or
empty.
Risk of engine damage. Once the war-
ning has been confirmed, the error mes-
sage is output every 120 sec. if the coo-
lant has not be topped up.
5.1.9F Engine coolant level sensor de-
fective.
No coolant level monitoring.
5.1.FF Comfort E-box no longer recei-
ving CAN data for engine
speed and PTO speed.
Various indicators no longer available or
comfort E-box fails completely.
Fault code Cause Effect and remedy
6.1.01 Button in cab faulty. Does not function, PTO disengages.
6.1.02 Key on right mudguard faulty. PTO can only be switched on/off with the
cab button. Button must be pressed for at
least 5 secs.
6.1.03 Button on left mudguard faulty. PTO can only be switched on/off with the
cab button. Button must be pressed for at
least 5 secs.
6.1.04 PTO shaft clutch solenoid valve
faulty.
Does not function, PTO disengages.

FENDT 926 Vario Specifications

General

Engine Power	260 hp
Transmission	Vario continuously variable transmission
Fuel Tank Capacity	500 liters
Weight	10, 500 kg
Engine type	6-cylinder turbocharged
Rated engine speed	2100 rpm
Displacement	7.5 liters
Number of cylinders	6
Maximum speed	50 km/h
Tire Options	Multiple options available