42
OPERATION
7.6 Changing direction of travel
The tractor slows to a standstill, then accelerates
in the desired direction until the previous trans-
mission ratio is reached.
The change of direction may be activated by:
- with the button on the steering wheel adjust-
ment.
- with the joystick.
Text-module
ETNum-list
ETNum-list
IMPORTANT:
An incomplete Quick Reverse operation is in-
dicated by flashing direction of travel indica-
tors. The selected change of direction is acti-
vated as soon as the problem is solved.
NOTE:
According to the selected acceleration rate,
the reverse will be executed more or less ra-
pidly.
Change of direction of travel using
button on the steering wheel lever
Operation_Pic_number:1
● Move the button (A) forwards or backwards.
The tractor slows down to a standstill and acce-
lerates in the opposite direction until it reaches
the previous transmission ratio.
● Keep the button (A) pressed forwards or
backwards.
Direction changing is cancelled when the
following are operated:
1.Joystick.
2.Neutral button.
The following factors will block the function,
but not terminate it:
1.Load limit control.
2.Final speed limit.
3.Engine speed above 2,600 rpm.
4.Turboclutch function.
Fig.56
The tractor slows to a standstill. When the button
(A) is released, the tractor continues in the pre-
vious travel direction and with the previous
transmission ratio.
Changing the direction of travel
using the joystick
Operation_Pic_number:1
Text-module
● Press and hold the activating button (C, on
back of joystick). While the tractor is moving,
push the joystick to the left.
If no change of travel direction has been pro-
grammed (see also OPERATION Section 7.7),
the tractor slows to a stop and accelerates in the
other direction of travel until it reaches the trans-
mission ratio that was active in the initial direc-
tion.
While the tractor is slowing, the preselected di-
rection of travel is shown by flashing of the cor-
responding indicator (B), and the current travel
direction by a steady light.
NOTE:
Optionally, a warning beep sounds when dri-
ving in reverse.
Fig.57
To Next Page
Loading...
Need help?
General
