43
OPERATION
7.7 Programmed changes of
travel direction
Text-module
NOTE:
The set values are only reached at an engine
speed of 1800 rpm.
Text-module
Using the control terminal, a forward speed and
a reverse speed can be pre-programmed.
Operation_Pic_number:1
Set values are shown on the display (A / C).
Function display (B / D).
Indicator red, speed programmed for change in
direction of travel.
Indicator white, speed not programmed for
change in direction of travel.
● Press key (F4). The following sub-menu ap-
pears.
Operation_Pic_number:1
● Press key (F1). The following submenu appe-
ars.
Fig.58
Fig.59
Operation_Pic_number:1
The set speeds are indicated by the indicators
(A and B).
(C) shows actual speed; below 0.5 km/h, the
values change from km/h to m/h.
Indicator from 100 m/h to 500 m/h.
Setting speeds
● Select forward speed with rotary switch (P1).
● Select reverse speed with rotary switch (P2).
Activating the selected speed
Operation_Pic_number:1
Activating stored forward speed
● Press key (F1).
● Display (A) changes from white to red.
Activating stored reverse speed
● Press key (F2).
● Indicator (B) changes from white to red.
Function indicator also appears on the first main
menu (see OPERATION Fig. 58).
Fig.60
Fig.61
To Next Page
Loading...
Need help?
General
