FERRI ZMT - Fire-Prevention Methods

21
Rev. 5.1
ZMT-ZMTE
SAFETY RULES
02-Misure antincendio
2.5 Fire-prevention methods
► Always keep a re extinguisher of adequate capacity on board the vehicle and make sure that it is periodically
recharged. The hand extinguisher is to be used by authorised personnel only.
► The personnel assigned to the vehicle must be trained in the reghting techniques adopted.
► All fuels and most lubricants and hydraulic uids are ammable.
► Switch o󰀨 the engine before lling the tank with fuel.
► Never smoke while lling the tank with fuel or topping up hydraulic uid levels.
► Never ll the fuel tank near open ames or in closed places.
► Never siphon fuel.
► Before starting the engine, make sure that there are no accumulations of spilt fuel, lubricants, or other uids
that might cause re in the vicinity.
► Short-circuits can cause res. Regularly check the conditions of the terminals to the batteries, cables, and
electrical appliances.
► Never store ammable substances in inappropriate places.
► Never puncture or burn pressurised containers or canisters.
► Never accumulate material soaked with ammable substances.
► In order to reduce the risk of combustion to a minimum, clean the machine regularly using the appropriate
equipment (compressed water or air spray cleaners).
When washing the machine, never spray water directly onto the electric boxes.
DANGER
► Use the appropriate re extinguishing methods (carbon dioxide, foam, chemical powder).
► Use sprays of water only to cool o󰀨 surfaces exposed to re.
► Never use petrol, solvent, or other ammable and/or toxic uids to clean mechanical parts. Use commercially
homologated, non-ammable, non-toxic solvents.
► Never weld near tanks, hoses, drums, electrical cables or electric materials in general.