FERRI ZMT - Positioning of the Machine During Operation

68
ZMT-ZMTE
Rev. 5.1
USE AND OPERATION
6.2
06-Posizionamento macchina ZMT-ZMTE
1
A
6.2 Positioning of the machine during operation
To position the machine correctly during operation, proceed as follows:
1) Make sure that there is su󰀩cient space between the working range of the machine and other equipment and/
or things.
2) Completely open tap (1) in position A to unblock the shredding ail head. In this way, using the controls in the
cab, the operator can put the machine into working phase from the transport position with the ail head in a
vertical position.
3) Lower the tractor three point coupling lifting device until the shredding ail head is parallel to the ground.
4) Adjust the three point coupling to the position required and lock it in place.
5) Familiarise yourself with the hydraulic control levers that manoeuvre the machine during work.