FERRI ZMT - Technical Data (ZMTE)

36
ZMT-ZMTE
Rev. 5.1
TECHNICAL CHARACTERISTICS
3.4
03-Dati tecnici (ZMT-ZMTE)
ZMTE1600 ZMTE1800 ZMTE2000
A
m 1,64 1,84 2,04
ft 5’ 5” 6’ 1” 6’ 8”
B
m 0,86 0,92 0,92
ft 2’ 10-1/20” 3’ 0-1/10” 3’ 0-1/10”
C
m 0,43 0,47 0,47
ft 1’ 5-1/20” 1’ 6-9/20” 1’ 6-9/20”
D
m 0,67 0,71 0,71
ft 2’ 2-1/5 “ 2’ 3-19/20” 2’ 3-19/20”
E
m 2,07 2,24 2,46
ft 6’ 10” 7’ 4” 8’ 1”
E
D
B
A
C
3.5 Technical Data (ZMTE)
TAB 1
Model ZMTE1600 ZMTE1800 ZMTE2000
Working width cm (in) 160 (63) 180 (71) 200 (79)
Max. lateral extension (*) cm (in) 280 (110) 300 (118) 320 (126)
Minimum/maximum tractor power HP (KW) 50/60 (36,8/44,1) 60/70 (44,1/51,5) 70/80 (51,5/58,9)
Min. tractor width cm (in) 180 (71) 200 (79) 220 (87)
Minimum tractor weight Kg (lbs) 2200 (4850) 2400 (5291) 2600 (5732)
PTO speed rpm 540
Max. absorbed power (**) HP (KW) 32 (23) 52 (38) 52 (38)
Machine weight/Shaft weight Kg (lbs) 533/25 (1175/55,1) 610/25 (1344/55,1) 636/25 (1402/55,1)
Tractor coupling cat. II-III
Rotor speed rpm 2430 2510 2510
Peripheral speed m/sec 46 50 50
Multi-use ails No. 40 48 48
Hammers No. 20 24 24
Articulated ails No. 56 64 72
Hydraulic system pressure Bar (PSI) 190 (2750)
Hydraulic oil type ISO-L-HM68
Belts No. 3 3 4
Max. inclination of shredding body degrees (low) 45° (high) 90°
(*) From the tractor axle to the end of the shredding ail head
(**) For work in which the absorption is above the maximum power indicated, use a PTO shaft with a clutch (torque
limiting device).
The tractor must be equipped with 2 double e󰀨ect oil inlets.
If only one oil inlet is available, it will be necessary to t a two lever distributor kit.
CAUTION