39
Rev. 5.1
ZMT-ZMTE
TECHNICAL CHARACTERISTICS
03-Utensili (ZMT-ZMTE)
3.8 Optional equipment
3.8.1 Flails
Depending on the dierent material to be cut, the most appropriate ails may be used.
The following table lists the cutting ails that may be tted on the machine and their respective characteristics.
DESCRIPTION
INTERCHANGEABLE ON
THE SAME ROTOR
Multi-use “Y” ails with a straight ail for grass, shrubs, sticks and bushes up to
3 cm (1.18 in) diameter.
Hammers for grass, wood and prunings up to 4 cm (1.57 in).
N.B.: Do not use on stony ground.
If irregularities or strange noises are noticed after changing the ails, contact the
manufacturer.
WARNING
Articulated “Y” ails with a straight ail for grass, shrubs and sticks up to 2.5
cm (0.98 in) diameter.
SPECIFIC
ROTOR
TYPE OF CUTTING FLAILS
To Next Page
Loading...