87
Rev. 5.1
ZMT-ZMTE
ROUTINE MAINTENANCE
07-Messa in parcheggio o deposito
7.9 Parkingorstorage
Whenever the machine will not be used for a long period of time, take the following measures to keep it in good
condition and free of dust and rust.
► Detach the machine from the tractor (see Chapter 4).
► Thoroughly wash the machine in order to remove all debris, residues, dirt or mud.
► Make a general visual inspection of the machine to identify any structural damage and/or deep abrasions on the
paintwork. Touch up all scratches and dents in the body with paint in order to prevent rust from forming. Replace
and/or repair any damaged parts.
► Check the integrity and the state of wear of the ails and supports. If worn, replace them.
► Check the integrity of the accident-prevention guards of the machine. Replace and/or repair any damaged guards.
► Inspect all hydraulic hoses, couplers and ttings. Tighten any loose ttings. Replace any hose that is damaged,
abraded or cut, or if the tting crimping is damaged.
► Check that the original safety decals are intact, legible and in their correct positions. Immediately replace any
damaged and/or illegible decals.
► If any lesions, abrasions or damage are found, make the necessary repairs.
► Grease all the mechanical parts, the tightening pins, and the coupling head to the PTO shaft. Make sure that all
grease cavities have been lled with grease in order to remove any residual water from washing the machine.
This operation protects the seal of the bearings.
► Store the machine in an area sheltered from atmospheric agents and far from all possible human activities.
► Store the machine in a at, dry area.
► Support the frame with the corresponding supports in order to increase the stability of the machine.
► Cover the machine with a tarpaulin, tying it suitably.
Never dispose of used oil into the environment. Oil is classied as special waste and must
be brought to the appropriate collection centres according to the regulations in force.
Contact the nearest Collection centre for used oil.
CAUTION
We recommend closing the tap of the suspension accumulator (LFA) to prevent it from discharging during the parking
period.
Clean the electronic power unit and its wiring if they are dirty or wet:
1) Disconnect the plug of the power unit;
2) Clean with a compressed air jet;
3) Spray an anti-rust product for electrical contacts.
4) Take care to apply some silicone (suitable for electric systems) to seal the screws of
the type DIN electric connectors that might have been removed for maintenance
operations.
CAUTION
To Next Page
Loading...