81
Rev. 5.1
ZMT-ZMTE
ROUTINE MAINTENANCE
7.1
07-Ingrassaggio
7.4 Greasing
LUBRICANT
TYPE CLASSIFICATION
AGIP GR MU EP/2 SAE90
► Use a hand-held grease gun for all greasing.
► Wipe the grease nozzle with a clean dry cloth, to avoid injecting dirt and grit.
► Under particularly taxing work conditions, perform lubrication operations more frequently than the every 8 hours
usually adopted.
► Replace or repair damaged or broken nozzles immediately.
► If the nozzles will not take grease, remove and clean them thoroughly. Also clean the lubricant passageway.
Replace the nozzle if necessary.
► In the event of long inactivity, repeat these operations before using the machine again.
INCREASE THE FREQUENCY OF MACHINE MAINTENANCE IF IT IS BEING USED IN
PARTICULARLY TAXING WORK CONDITIONS.
CAUTION
To Next Page
Loading...