FERRI ZMT - Replacing Safety Decals

29
Rev. 5.1
ZMT-ZMTE
SAFETY RULES
02-Sostituzione pittogrammi di sicurezza
2.8.1 Replacingsafetydecals
► Make sure that the area of application is clean and dry.
► Determine the exact position before you remove the protective paper from the decal.
► Remove a small portion of the protective paper from the adhesive decal.
► Align the decal over the specied area and carefully press the small exposed adhesive part.
► Remove the remaining part of the protective paper from the adhesive part and carefully press all over the decal
until it sticks to the surface completely.
► The tiny blisters of air that may form and remain trapped beneath the surface of the decal can be eliminated
by puncturing with a pin and then the decal can be attened out by rubbing the previously removed protective
paper backing over the decal surface.