FERRI ZMT - Transport Position

72
ZMT-ZMTE
Rev. 5.1
USE AND OPERATION
6.3
06-Posizione di trasporto (ZMT-ZMTE)
2
1
3
A
6.6 Transport position
For transport by road it is necessary to:
► Position the ail head parallel to the ground.
► Block the ail head as follows:
1) Insert the pin in the appropriate housing (1);
2) Introduce the holding pins (2);
3) Ensure a blocked stationary position during transport.
► Use the ram to position the shredder as close as possible to the tractor.
► To avoid the machine arms opening whilst on the road, close tap (3) positioning the lever in position “A”.
► Attach appropriate signs indicating machine overall dimensions and footprint.
► Do not lift the machine excessively to prevent the PTO shaft, with the power take o󰀨 disconnected, exceeding
30° inclination and becoming damaged.
► Fit a rear bar with warning lights if the machine prole covers the tractor tail lights.
► Check that the levers operating hydraulic lifting are blocked, to avoid the machine coming down during transport.
► Observe all the road transport requirements.
► Consult paragraph 2.2 - Safety rules concerning road tra󰀩c in this manual.