52
ZMT-ZMTE
Rev. 5.1
TRANSPORT AND INSTALLATION
04-Attacco alla trattrice
4.3 Coupling to tractor
Prior to coupling the machine to the tractor, make sure that:
A) All the controls have been disabled;
B) The tractor engine has been switched o;
C) The parking brake has been applied;
D) The ignition key has been removed from the dashboard;
E) All moving parts have come to a complete stop.
DANGER
Illuminate the work areas whenever visibility is scarce.
During coupling operations keep all unauthorised people at least 5 metres away from the coupling point.
Position the tractor on a level compact area to avoid lateral loading of the machine on
the stabilisers.
WARNING
► Before connecting the machine to the three-point coupling on the tractor, position the safety device of the lifting
arm in order to avoid involuntary and/or accidental lifting or lowering.
► The three-point coupling on the tractor and the machine must coincide. If they do not, adapt them accordingly.
In the tractor lifting arm linkage system zone there is a risk of injury due to the presence
of points where crushing and cutting can occur.
Do not use the external control for lifting the machine.
DANGER
During coupling phases do not allow anybody to remain between the tractor and the tool.
CAUTION
To Next Page
Loading...