CMMP-AS-...-M0
6 Festo – GDCP-CMMP-M0-FW-E N – 1304N H
Instruc tions on this desc ription
This document is intended to help you work safely with the CMMP-AS-…-M0 motor controllers.
It includes safety instructions tha t must be observed.
You will find more extensive information on the CMMP-AS-…-M0 motor controller Ta b. 1.
• Unconditionally observe the general safety regulations for the CMMP-AS -...-M0.
The general safety regulations for the CMMP-AS-...-M0 can be found in the hardware
description, GDCP-CMMP-AS -M0-HW-..., see Tab. 1.
Target group
This desc ription is intended exclusively for technicians trained in c ontrol and automation technology,
who have experience in installation, commissioning, programming and diagnosing of positioning sys-
tems.
Service
Please consult your regional Festo contact if you have any tec hnic al problems.
Produc t identification, versions
This description refers to the following versions:
– Motor controller CMMP-AS -...-M0 from Rev 01
– Firmware from Version 4.0.1501.1.2
– FCT-PlugIn CMMP-AS from Version 2.2.x.
This description does not apply to the older variants CMMP-AS-...
Note
With newer firmware versions, check whether there is a newer version of this descrip-
tion available: www.festo.com
To Next Page
Loading...
Need help?
General
