1 Safety and requirements for product use
10 Festo – GDCP-CMMS-AS-G2-HW-EN – 1310NH – English
1.2 Requirements for product use
• Make this documentation available to the design engineer, installer and personnel responsible for
commissioning the machine or system in which this produc t is used.
• Make sure that the specifications of the documentation are always c omplied with. Also consider the
documentation for the other c omponents and modules.
• Take into consideration the legal regulations applicable for the destination, as well as:
– regulations and standards,
– regulations of the testing organizations and insurers,
– national spe cifications.
1.2.1 Technical requirements
For correct and safe use of the product:
• Comply with the c onnection and environmental c onditions of the product ( Appendix A) and all
connected components specified in the technical data. Compliance with the limit values and load
limits permits operation of the product in compliance with the relevant safety regulations.
• Observe the instructions and warnings in this documentation.
1.2.2 Qualification of trained pe rsonnel
The product may only be placed in operation by a qualified electrotechnician who is familiar with:
– the installation and operation of electrical control systems,
– the applicable regulations for operating safety-engineered systems,
– the applicable regulations for acc ident protection and occupational safety and
– the documentation for the product.
1.2.3 Range of application and certifications
The motor controller with integrated STO safety function is a safety-related part of the control systems.
The motor controller carries the CE marking; for standards and test values Appendix A.1.
The EU directives that are relevant for the produc t can be found in the declaration of conformity.
Certificates and the declaration of c onformity for this product www.festo.com.