3 Mechanical installation
Festo – GDCP-CMMS-AS-G2-HW-EN – 1310NH – English 19
3.2 Assembly
Warning
Danger of electric shock.
Touching live par ts causes severe injuries and can lead to death. Do not disconnect
connecting cables when powered. Before mounting and installation work:
1. Switch off power to the electrical equipment via the mains switch and secure it
against being switched on again.
2. After switch-off, wait at least 5 minutes discharge time and check that power is
turned off before accessing the controller.
Caution
Danger of burns from hot surfaces
Dependent on the load of the motor c ontroller, housing temperatures > 80° C are pos-
sible in operation.
• Only touch in a switched-off, cooled-off state.
Note
Make sure that no metal shavings, metal dust or mounting pa rts (screws, nuts, pieces of
wire) fall into the motor controller when mounting and during operation.