Creator3 User Guide | www.flashforge.com 400-699-1063
The surface on which the Creator3 builds an object.
The blue tape that covers Creator3’s build plate so that
the object can stick to the build plate well.
The three dimensional amount of space that an object
will use once it is completed. The largest build volume
of Creator3 is 300*250*200 mm.
Nuts under the build platform that are used for
adjusting the distance between the nozzle and build
plate.
The device that draws the filament from the spool,
melts it and pushes it through a nozzle into the build
plate.
Also called “print head”, which located at the bottom
of the extruder where heated filament is squeezed out.
To cool the outer assembly of the extruder and gear
motor.
An opening located at the top of the extruder.
A plastic piece that guides the filament from the
filament box to the filament intake.
A solid adhesive used for making the model stick to the
build plate firmly.
A tool that used for cleaning and unclogging the
extruder.
A tool that used for seizing the nozzle’s metal cube.
A specific box for placing FlashForge filament.
To Next Page
Loading...
