Flashforge Creator3 - Filament Preheat

Creator3 User Guide | www.flashforge.com 400-699-1063
19
Filament Preheat
a. Left extruder preheat progress;
b. Right extruder preheat progress;
c. Actual temperature/target temperature;
d. Actual temperature/target temperature;
e. Cancel:Tap [Cancel] button to abort
preheat job.
f. Back.
g. Done: Operate according to the
instruction on the touch screen,tap [Done] to
finish filament load.
h. Done: Operate according to the
instruction on the touch screen,tap [Done] to
finish filament unload.
a
b
c
d
f
e
g
h