Creator3 User Guide | www.flashforge.com 400-699-1063
After generating the Gcode file, you can transfer it to your Creator3. You can transfer
the file through Ethernet Cable or WiFi or USB stick.
7.2.1 Print from Computer ( Ethernet Cable connection)
①Connect your Creator3 with your PC via a Ethernet cable.(Please refer to 6.2.13 )
②Turn on your Creator3, level the build plate and load the filament.
③ Click [Print] and transfer your Gcode file to your Creator3. After completing
transference, the printer will heat up automatically. And when heating finishes, the
printer will start to build the model.
④ When your PC connects with FlashPrint successfully. The status box on the
bottom right displays the real-time nozzle temperature. After finishing preheating,
your Creator3 starts the print job directly.
To Next Page
Loading...
